I followed the instructions in the article
https://www-secure.symantec.com/connect/articles/h...
but I am still receiving a "Job Completed with Exceptions" status. In my job log, I am still getting the V-79-40960-37914 code in the exceptions area. I double-checked my database selection for this job to make sure that every database selected is indeed set with the recovery mode of "full". Like the instructions, I have one full and two incremental backups scheduled within this job. AOF is disabled. The first incremental job is set with the "Incremental method for Microsoft SQL" setting to "log" and the second incremental job is set to "differential". I also staggered the start times of each job. At this point, I'm not sure what I am missing.
I did notice in my SQL Server Management Studio, that some of the databases are set with a compatibility level of "SQL Server 2005 (90)" and others have "SQL Server 2008 (100)". Do I need to account for these settings anywhere within Backup Exec? For my current backup job, under the Microsoft SQL section, I have the current settngs configured for all three jobs:
-Consistency check before backup: Physical check only
-Enable "Continue with backup if consistency check fails"
-Consistency check after backup: None
-Disable "Use checksum on backups"
-Disable "Create on-disk space of SQL backups to be placed on the SQL server where the database is located"
-SQL Server 2008 Enterprise Edition software compress: None
Any help or suggestions would be greatly appreciated. Thank you.